10 Min Buffer

Difficulty: Beginner

All Kits are Assembled in Australia

Not sure what parts to order? Learn more in this short video


10 Min Buffer


Just about the easiest / lowest part count buffer there is! Very small, a good candidate for a guitar cavity buffer or small enclosure


Dimensions: 29mm x 12mm

PCB Sizing: 1590a enclosure (no-special hardware required) or larger

*** Base price is for PCB only, please select kit options above to order kit components


Kit Options
Please select the kit options you would like included with your PCB from the checkboxes above

•   PCB Components
"PCB Components" includes all onboard components you need to build the "10 Min Buffer". Battery snap is included as well as 6 lenghts of wire. Also includes, LED, current limiting resistor ("medium" brightness) and plastic bezel for mounting the led to an enclosure.


•   Mono Jacks (2 of)
!! Due to stock scarcity Nuetrik mono jacks may be sent in place of lumberg mono jacks !!
"Compact Mono Jacks (2of)" include 2 Lumberg compact mono jacks with your kit. These jacks are small in size, a good choice for tight builds and beginners but can be used for any build. Please note you will need a stereo jack if you plan to power your effect with a battery. (Stereo jacks are available in the hardware section of this store).





•  Miniature DC Jack
These DC jacks are very small and are suitable for any build not using a battery / battery switching. Especially good for 1590a builds as they are very compact.



What else do i need to complete this project?

You will need an enclosure and a 3pdt footswitch to complete this project, if you order all available kit component options above.


Downloads
Bill of Materials & Build Guide
Schematic